Blenders | The Blender Co.

Two ways to buy

Pick your starting point

Most customers start with a standard model. When the fluid, the volume, or the floor doesn't fit a catalog, we build one from scratch.

Standard line

Ready-built blenders

Proven designs for the fluids most operations run every day, such as water-mix coolants, wash solutions, and glycols. Short lead times and predictable pricing.

Point-of-use units sized for a single machine or cell, including standard Haas setups
Central blenders that feed a full floor or a bulk tank
Level and flow measurement included

Custom builds

Engineered around your fluid

Multiple components, unusual ratios, high viscosity, tight tolerances, or a footprint nobody else will fit. We design, build, and test the machine in our shop before it ships.

Engineering review of your fluid and process
Materials and seals selected for your chemistry
Concentration measurement where the ratio is critical

Measurement and control

We measure what we make

A blender is only as good as what it knows about the fluid. We pick the measurement for the job, not the other way around.

Level sensing on every tank, so the machine knows when to make more and never runs dry or overflows
Flow metering on each input, so the ratio is set by what actually went in, not by a valve setting
Concentration measurement on the finished blend for customers who need to verify the mix, not just calculate it
Every batch logged with time, volume, and ratio

Stainless pressure vessel with gauges and fittings

Before and after

How a Blender Co. machine compares

Most operations mix by hand or with a simple proportioner. Here's what changes.

	Hand mixing or proportioner	The Blender Co.
Ratio	Depends on water pressure, wear, and who did it	Set once, held on every batch
Verification	Occasional spot checks, if any	Measured on the machine
Fluids	One fluid per device, limited ratios	Any fluid, single or multi-component
Labor	Buckets, drums, and someone's time	Runs on its own, alerts when it needs attention
Records	A clipboard, if anything	Every batch logged and exportable

How a custom build works

From your fluid to a finished machine

We learn your fluid, your volumes, and where the machine will live.
We propose a design, the measurement it needs, and a firm quote.
We build and test it in our Columbus shop with your fluid.
We install, commission, and train your team.

Questions

Frequently asked

What fluids can you blend?

Almost anything that flows: water-mix coolants and cutting fluids, lubricants, wash and rinse chemistries, rust preventives, glycols, and specialty process fluids. Tell us what you're mixing and we'll confirm fit.

Do I need a custom machine?

Usually not. Most single-fluid, water-mix applications fit a standard model. We'll tell you honestly if a standard unit will do the job.

Can you verify the concentration of the blend?

Yes. On applications where the ratio is critical, we add concentration measurement on the finished fluid so the blend is checked, not just calculated.

Will it work with our existing machines?

Our standard point-of-use units are sized for common setups, including standard Haas machines. Central blenders connect to your existing tanks or distribution lines.

What does it cost?

Standard models are quoted by size and options. Custom builds are quoted after a short engineering review. Contact us with your fluid and volumes and we'll follow up.

Standard when you can. Custom when you need it.